CAM038AHD - Bumper Mount Flush 1080P AHD Reversing Camera - (Only works with 1080P AHD compatible monitors/DVR's)

Description

About the 1080P AHD Flush Bumper Reversing Camera

One of our most subtle reversing cameras is the flush-fitting bumper mount type. Comes with a 28mm hole-saw to produce the correct sized hole for mounting. Insert the reverse camera inside, then screw up the locking ring to the rear of the camera. These cameras have a threaded body, so the locking ring twists to secure camera in place. There are angled spacers too, should you need to compensate for a mild tilt to the vertical surface that you plan to mount this. Instructions can be downloaded further down this listing. Please see warning regarding compatibility. This is designed to fit AHD monitors or DVR's that can accept 1080P AHD inputs. If you are looking for an AHD monitor then please see our AHD monitors category.

AHD signal cameras will NOT work with 99% of monitors and car stereos currently in use. This camera requires a special AHD monitor that can read the AHD signal produced by the camera. Ensure your AHD monitor or recorder can handle 1080P AHD inputs. If you do not have a confirmed AHD monitor, then please purchase instead from our large range of high resolution traditional cameras.

Technical Specs

Image Sensor : 1/2.7 CMOS 2399
Effective Pixels : 1920(H) * 1080(V)
TV System : PAL
Lens : 1.9mm
Min illumination 0Lux (LED ON)
IR LED : 10pcs
Night Vision Distance : 10M
Waterproof : IP68
Viewing angle : 95°(D) x75°(H) x60°(V)
Power Voltage : 12V
Current Consumption : 150 mA
Operating temperature : -20℃~+70℃