10M (with 8mm link) - Twin 4 Pin Aviation Screw Connector Extension Cable for 2 reversing cameras | CAB10Y-8mm

• Our 10M length two channel/signal 4 pin top quality extension cable for reversing cameras. 
• This version comes with a small 8mm diameter disconnect link point 100cm back from the connector at the front of the cable. This was placed there so that the larger 15mm diameter connector could be unplugged (to get through tight gaps) and then reconnected once you arrive close to your monitors channel inputs.
• We call these Y cables, since the shape of the ends look like the letter Y, as they are a single cable to make running cables easier, but then split to two male connectors for the reversing/rear view cameras, and two female connectors to feed a monitor.
• Fully waterproof connection, comes with screw locking collar that compresses the connection against the rubber O ring inside. Please note that the 8mm disconnect link isn't waterproof, so will need to be inside (as this is placed at the front of the cable, this part is usually next to the monitor and isn't an issue).
• Our extension cables are made from pure copper (not the cheaper CCA/CCS which is prone to failure).
• The cable has screening around the video signal wire, as well as aluminium foil around covering all of the wires inside the cable - to protect against outside interference, as well as allowing you to coil up any excess cable.
• This cable is not suitable for the latest range of 1080P AHD reversing cameras (although we have developed a version of this cable that is currently being produced that will be). Our single channel cables will support the high frequency AHD cameras until we get the new design twin cables delivered.

We now have an upgraded version of this cable that can support 2x AHD High Definition Reversing cameras (this isn't possible with the standard version). If required, please select this upgrade using the drop down menu above.