7" Mirror Monitor + Adaptor I - Replacement screen compatible with Sargent / Swift / Autotrail / Bessacarr motorhomes

Monitor + Adaptor Bundle Set that allows our 7 inch rear view mirror monitor to replace the Sargent Electrical RVM720/730 Mirror Monitors fitted to Swift / Autotrail / Bessacarr motorhomes

An adaptor bundle set, designed to replace the mirror monitor on Sargent Electrical reversing camera systems that use the EM3.5, EM5.0, and EM5.6 boxes. Commonly seen on Swift, Autotrail, Bessacarr motorhomes. Our mirror monitor uses a slimline 8 pin plug, which then fits to our Adaptor I (converts to a PS/2 connector, which we have had pinned out to match Sargent's cabling).

We often sell the 7 inch swan neck bracket monitor for people wishing to upgrade their standard small display panel, to our larger 7 inch diagonally measured panel mirror display.

Please kindly note :- Our recent delivery of adaptors were made incorrectly.  The adaptor you receive will have been opened up and made correct, then sealed with a yellow sleeve of heat shrink.

Choose from either a clip over mirror monitor, or the windscreen swan neck mirror monitor (see below for guidance)

Clip over original mirror Mounting

This type of mirror monitor has spring loaded clamps on the rear, instead of 4 screw holes for our swan neck brackets to fit. These clamps secure the monitor against an interior mirror.

Bracket Mirror Monitor Only (fits to original swan neck mount)

This option allows you to purchase the new monitor and utilise the existing mount that you have attached to the old monitor.  The 4 screw holes have the same offset as our monitors, so the original mount can be attached to our mirror

ACCMB7 (Earlier Vans) Mounting

Often seen on earlier models of the Fiat Ducato/Peugeot Boxer/Citroen Relay vans.  Although we have seen this fitted to some vans as late as 2020!

ACCMB2 + MP35 (Later Vans) Mounting

This fits to a type of windscreen button typically found on later versions of Fiat Ducato, Peugeot Boxer, and Citroen Relay vans (those fitted without rain sensors). It usually has a black circular cover over it, as well as a spring clip, both of these need removing prior to install. We used to stock a twist version of the swan neck bracket, but we much prefer this method due to the ease of fitting.