Waeco/Dometic/Baileys/Burstner motorhomes Pre-fitted Cable Adaptors 2010 onwards to Twin 4 pin aviation | CAB001WY

Waeco / Dometic / Baileys / Burstner Motorhome Pre-fitted Cable compatible reversing camera adaptors 2010+ for two camera signals

• We created these adaptors to fit the 6 pin screw reversing camera cable that was created by Waeco/Dometic since 2010
• This type of cable is often pre-fitted to Baileys, and Burstner Motorhomes, as well as other brands
• This version of the adaptor will allow you to run a single camera feed down this pre-fitted reversing camera cable
• The adaptors are sold in pairs, and this is the only guaranteed way they will work. We found 3 pin-out variations on the cables when we were researching. We picked the most common. When you use in pairs, they will always work. But if you intend to try and just use one adaptor eg to replace just one part of a failed Waeco/Dometic system, there is a chance it won't work.
• The adaptors allow you to use two standard 4 pin "aviation" connector cameras + monitor with the pre-fitted Waeco / Dometic cable, either with a twin camera, or two separate cameras
• Please kindly note that these adaptors are not suitable for the new AHD high definition technology cameras available on the market. This is due to the higher shielding requirements required for the high frequency signal.

Our video showing us fitting these adaptor cables on a Burstner T620 Travel Van in order to replace a CAM45 Dometic reversing camera. This cable is fitted to Baileys, Burstner and some other motorhome brands. The adaptors on this page allow you to fit or change the reversing camera on your motorhome.