CAM222WLens 1x Spare Lens for Twin Lens camera (Please select Wide or Narrow angle from inside listing)

Yes, as default we will supply the camera with a small 8mm diameter disconnect, which then changes to the larger 4 pin screw connector.

Please note that the small disconnect points can be wired entirely differently despite looking identical. We have two versions of the twin lens (from two different factories), which are wired up differently—one with red tape (in the photo) and the other with brown tape. If your existing camera has colour tape, chances are we will have supplied it. In this case, we can provide one to match if the colour is stated on the customer notes during checkout.

If there is no tape next to the 8mm connector point, then chances are it was supplied by someone else. The two most common suppliers that only use the small 8mm diameter connector on their twin lens with no conversion further back to 4 pins are Vision UK™ and Vision Plus™. Oddly enough, they wired them up the same way. We do have an adaptor to allow our twin lens to work with their pin outs. The adaptor is from the 4 pin connection, so you do have a small daisy chain of leads in the back if you choose this option. Usually both suppliers have Vision written on the front of their monitor, plus often a sticker to the rear of camera/monitor saying Vision too. If you believe yours is the VisionUK or Vision Plus supplied camera, please also purchase our Adaptor for Vision UK™ and Vision Plus™ reversing cameras : https://www.parkingcameras.com/store/adaptor-v-reversing-camera-adaptor-for-Vision.html 

The daisy chain if you require the adaptor V will look like the photo below : 

We don't; however, we can supply an adaptor cable to achieve the same end result : Reversing Camera Adaptor Cable to go from 4 Pin Connector to Phono/RCA + DC Sockets.